In the BITalino Freestyle how are individual blocks powered?

General information about BITalino
BITalino
Site Admin
Posts: 567
Joined: Tue Aug 27, 2013 3:47 pm

In the BITalino Freestyle how are individual blocks powered?

Postby BITalino » Mon Nov 04, 2013 9:38 am

BITalino Freestyle is our most flexible model, in which you need to hardwire the Vcc, Gnd, and Vcc/2 midpoint voltage (when applicable), as well as the output of the sensor to inputs on the MCU.

Note that in this case, you can also easily connect the sensors to any electrically compatible third-party board (e.g. Arduino, or Lilypad). The pinout is available online in the hardware manual:

http://www.biosignalsplux.com/downloads ... anual.html

Return to “BITalino kits”