Page 1 of 1

How to change the default network settings on BITalino R-IoT

Posted: Tue Oct 17, 2017 5:06 pm
by rfreixo
By default the device is programmed to connect to a network named "riot". You can change default setting making device enter on Association Point (AP) mode and then selecting new settings.

AP Mode
1) Connect GPIO28 to GND;
AP_mode.jpg (123.25 KiB) Viewed 140 times

2) Connect battery and turn device on. The led will blink red (very fast), then will turn blue and finally green; ... WxlcWRpWUE

Connect to R-IoT
1) On your laptop connect to a network named "riot-xxxx";
image.png (183.23 KiB) Viewed 140 times

2) Open your browser and write "". Select the new configurations and click on "submit";
image (1).png
image (1).png (203.16 KiB) Viewed 140 times

3) Turn off and turn on. The device is now ready with new configurations;